FAQs

FAQ Search
Most Recently Published FAQs

Results 1 - 10 of 100

FAQ ID Description
FA12064 How to change page resolution in configured project of Vijeo Citect?
In order to change the resolution of the pages in Vijeo Citect project do following things:          1. Add the following INI parameter through Computer...
FA12077Is it possible to give continuous supply to the Shunt Trip (MX) coil of circuit breaker?
Yes, you can keep the supply ON continuously for the Shunt Trip coil (MX) of Circuit Breaker as new technology permits this without damaging the Shunt...
FA12101What are the minimum and maximum cable sizes recommended for use with TeSys D Star-Delta connection kits?
The minimum and maximum cable sizes recommended to be used with TeSys D Star-Delta kits are:   Kit Minimum (Sq. mm) Maximum (Sq....
FA12105Is it possible to install the rectangular sensor at the incoming side of the Masterpact ACB with Micrologic 7.0?
Yes, it is possible to install the rectangular sensor at the incoming side of the Masterpact Air circuit breaker (ACB). The earth leakage protection...
FA12109How to connect the Vigi Module with Compact NS MCCB?
Refer the Vigi Installation Guide for the instruction to connect the Vigi module on the Compact NS Moulded Case Circuit Breaker (MCCB). Caution:...
FA12115How to enable the Navigation Panel option in ProWorx32?
To enable the Navigation Panel option in ProWorx32, check the 'Enable Scrolling Navigation Panel' option in the properties window of ProWorx32 Software. Refer...
FA12126What are the different Communication Networks on which the Altivar 61 Drive can be communicated?
The different Communication Networks on which the Altivar 61 Drive be communicated are as follows: 1. Ethernet TCP/IP 2. Modbus/Unitelway 3. Fipio 4....
FA12131Which power phases are controlled by Altistart 01 Soft-Starter?
The power phases that are controlled by Altistart 01 Soft-Starter are as follows: In N1 Range of Altistart 01 Soft-Starter only 1 Phase is controlled...
FA12132What is the Earth Leakage current value for an Altivar 31 Drive?
Refer attachment for the Earth Leakage current values for Altivar 31 Drive. Note: The earth leakage current strongly depends on how well the input...
FA12160What is the maximum cable length allowed for connection of the Remote display of the Altivar 71 Drive?
The maximum cable length allowed for connection of the Remote display of the Altivar 71 Drive is 10 Meters.

Results 1 - 10 of 100